Position both pads on the wire upstream of the wire input (to the welder or drum):
Drenched (green) PAD, followed by dry (white) PAD.
For this purpose, PADs are folded in the middle and the CLIPs are pushed over the PADs from the side where the fold is.
The wire must run through directly through the fold on the PADs.
Initial use with new liner, as otherwise old contamination would come out.
We also recommend using Twin-Pads on contaminated wires or wires that are subject to a complaint. In many cases the wire will process properly, then.
Not suitable for aluminium.
Set ready for application
ID no. W001.S01
Recommended as follow-on order:
PROTEC WLS04 wire balm set
Contains WLS04 spray, PADs and clips.
ID no. W001.S02
Copyright 2018 PROTEC® Trading GmbH. All rights reserved.